Tracking Features:
Total 216 channels: all-in-view, GPS L1/L2/L2C/L5, Galileo E1/E5A, GLONASS L1/L2,
KFK WAAS/EGNOS (SBAS), BeiDou, Advanced Multipath Reduction, Fast acquisition channels, High accuracy velocity measurement, Almost unlimited altitude and velocity (for authorized users)
Data Features:Up to 100 Hz update rate for real time position and raw data (code and carrier), 10 cm code phase and 1 mm carrier phase precision, Hardware Viterbi decoder, RTCM SC104 versions 2.x and 3.x Input/Output, NMEA 0183 versions 2.x and 3.0 Output, Code Differential Rover, Code Differential Base, Geoid and Magnetic Variation models, RAIM, Different DATUMs support, Output of grid coordinates, IEEE 1588 Master Clock
Data Storage:Up to 2048MB of onboard non-removable memory for data storage
Input/Output:Two high speed RS232 serial ports (up to 460.8 Kbps), Two high speed configurable RS232/RS422 RS232/RS422 serial ports (up to 460.8 Kbps), High speed USB 2.0 device port (480 Mbps), Full-duplex 10BASE-T/100BASE-TX Ethernet port, Two CAN 2.0 A/B ports, IRIG timecode output, Two 1-PPS outputs synchronized to GPS, GLONASS or UTC, Two Event Marker inputs, External Frequency Input/Output, MinPad interface: Four external LED drivers, ON/OFF control and External Command inputs, Four Configurable Lodic-Level GPIO ports
Specifications
Physical
Electrical
Connector type: 64-pin DIN41612 type B Right Angle, AMP p/n 536052-5.
All the RF connectors are MMCX Jack, Edge Mount, AMPHENOL, P/N 908-22100.
| Description | Signal Name | Pin # | Pin # | Signal Name | Description |
|---|
| Power Ground | PGND | A1 | B1 | PGND | Power Ground |
|---|
| +4.5 to +40 VDC Power Input | PWR_IN | A2 | B2 | PWR_IN | +4.5 to +40 VDC Power Input |
|---|
| Factory use only, must be left open | FUO | A3 | B3 | COMMSW# | Active Low Command Input (FN Button) |
|---|
| Reserved | - | A4 | B4 | KA_PWR | Keep-Alive Power Input for Real-Time Clock (+4.5 to +40 VDC, 10µA typ) |
|---|
| External LED Control | LED2_RED | A5 | B5 | LED1_RED | External LED Control |
|---|
| External LED Control | LED2_GRN | A6 | B6 | LED1_GRN | External LED Control |
|---|
| Signal Ground | GND | A7 | B7 | USB_PWR | USB port Power Input line |
|---|
| USB port D- line | USB_D- | A8 | B8 | USB_D+ | USB port D+ line |
|---|
| Serial port A: RS232 TXD line | TXDA | A9 | B9 | CTSA | Serial port A: RS232 CTS line |
|---|
| Serial port A: RS232 RXD line | RXDA | A10 | B10 | RTSA | Serial port A: RS232 RTS line |
|---|
| Serial port C: RS232 TXD line or RS422 TX- line | TXDC/TXC- | A11 | B11 | CTSC/RXC+ | Serial port C: RS232 CTS line or RS422 RX+ line |
|---|
| Serial port C: RS232 RXD line or RS422 RX- line | RXDC/RXC- | A12 | B12 | RTSC/TXC+ | Serial port C: RS232 RTS line or RS422 TX+ line |
|---|
| Serial port D: RS232 RTS line or RS422 TX+ line | RTSD/TXD+ | A13 | B13 | TXDD/TXD- | Serial port D: RS232 TXD line or RS422 TX- line |
|---|
| Serial port D: RS232 CTS line or RS422 RX+ line | CTSD/RXD+ | A14 | B14 | RXDD/RXD- | Serial port D: RS232 RXD line or RS422 RX- line |
|---|
| Signal Ground | GND | A15 | B15 | - | Reserved |
|---|
| Reserved | - | A16 | B16 | - | Reserved |
|---|
| Serial port B: RS232 TXD line | TXDB | A17 | B17 | CTSB | Serial port B: RS232 CTS line |
|---|
| Serial port B: RS232 RXD line | RXDB | A18 | B18 | RTSB | Serial port B: RS232 RTS line |
|---|
| CAN1 port CAN-H line | CAN1H | A19 | B19 | CAN1L | CAN1 port CAN-L line |
|---|
| CAN2 port CAN-H line | CAN2H | A20 | B20 | CAN2L | CAN2 port CAN-L line |
|---|
| Factory use only, must be left open | FUO | A21 | B21 | - | Reserved |
|---|
| Signal Ground | GND | A22 | B22 | 1PPSA | 1 Puls Per Second output A |
|---|
| Signal Ground | GND | A23 | B23 | 1PPSB | 1 Puls Per Second output N |
|---|
| Signal Ground | GND | A24 | B24 | EVENTA | Event input A |
|---|
| Signal Ground | GND | A25 | B25 | EVENTB | Event input B |
|---|
| Configurable Logic-Level I/O 0 line | GPIO0 | A26 | B26 | GPIO1 | Configurable Logic-Level I/O 1 line |
|---|
| Configurable Logic-Level I/O 2 line | GPIO2 | A27 | B27 | GPIO3 | Configurable Logic-Level I/O 3 line |
|---|
| Signal Ground | GND | A28 | B28 | RESET_IN# | Active Low Reset input |
|---|
| Ethernet port TX+ line | LAN_TX+ | A29 | B29 | LAN_TX- | Ethernet port TX- line |
|---|
| Signal Ground | GND | A30 | B30 | LAN_LED | Ethernet port control for external LED |
|---|
| Ethernet port RX+ line | LAN_RX+ | A31 | B31 | LAN_RX- | Ethernet port RX- line |
|---|
| Active Low input for ON/OFF switch | ONOFFSW# | A32 | B32 | IRIG_OUT | IRIG port output line |
|---|
Environmental
Operating Temperature: -40°C to +80°C
Storage Temperature: -40°C to +85°C
High shock and vibration resistance
